Introduction Goniophotometry is a very effective measuring method that is crucial to the LED characterisation process. It allows for the accurate assessment of a wide range of photometric and radiometric characteristics, shedding information on the efficacy, output, and spatial distribution of light from LEDs. The importance of goniophotometry in LED characterisation is discussed, with an emphasis...
Introduction When it comes to correctly and dependably measuring color, a wide variety of companies rely on spectroradiometer integrating sphere systems of the greatest quality. The constant illumination and comprehensive spectrum information provided by these devices make it feasible to conduct accurate colorimetry analyses. Nevertheless, the outcomes of the measurements might be influenced by va...
8. Accessibility of Live Parts 8.1 An electrical part of a heater shall be so located or enclosed that protection against unintentional contact with uninsulated live parts will be provided, except that this requirement does not apply to a visibly glowing open-wire element and the connections immediately adjacent to the element. See 3.1, 8.2,32.7 and 32.14. Insulated motor brush caps do not require...
The burst generator is also called burst tester, is a kind of EMI filter, and its name comes from the “Electrical Fast Transient/burst” (abbreviated as EFT) experiment. The EFT experiment is an immunity test experiment, which is divided into four levels according to the IEC61000-4-4 standard. Different levels of EFT generators have different injection voltages or cargo coupling voltage...
Introduction To guarantee their safe and dependable performance under harsh environments, aircraft components and systems must undergo extensive testing and validation within the aerospace industry. Aerospace testing relies heavily on altitude condition modeling, which entails recreating the low-pressure and low-temperature settings seen at high altitudes. Environmental test chambers are essential...
19.15 For battery-operated appliances incorporating a manual voltage selector switch intended to select battery voltage, this switch is set to the lowest voltage position and the highest voltage is applied. B.19.1 The supply terminals of a battery-operated appliance having an indication of polarity are connected to the battery terminals of the opposite polarity, unless such a connection by the use...
In addition to components such as compressors, pressure accumulators, condensers, and dryers, the refrigeration system of the high and low temperature test chamber also has several parts such as capillary tubes, solenoid valves, evaporators, and pressure protection. The combination of mechanical refrigeration and liquid nitrogen refrigeration is used. It consists of two parts and each part is a re...
Introduction Accurate diagnosis and treatment planning are only possible with the use of medical imaging, which plays a crucial role in contemporary healthcare. The quality of imaging findings and patient safety may be jeopardized, however, if electromagnetic interference (EMI) from outside sources disrupts the dependable functioning of medical imaging equipment. Efficiently assessing and mitigati...
Through the test of the UV aging test chamber, the performance change of the material under different ultraviolet radiation can be evaluated, such as the color change of the material, the change of the surface quality, the change of physical properties, etc., so as to carry out the development and improvement of subsequent products. Widely used in plastics, coatings, rubber, textiles, cosmetics, a...
中文简体
English
Русский
Español
Português
Türkçe
العربية
Deutsch
Polski
Italiano
Français
한국어
ไทย
Tiếng Việt
日本語