How to do ESD test? Here are a few simple steps: 1. Air discharge/contact discharge a) First turn on the switch power b) Then enter the selector switch, select air discharge or contact discharge c) When air discharge is selected, press the HV ON switch button (before pressing the switch, make sure that the OUTPUT ESD discharge gun is inserted into the socket, and the VOLTS ADJUST knob is turned fu...
Application: The horizontal and vertical needle flame tester UL94 is mainly used to determine the combustion performance of plastic, rubber or film under a specified fire source to determine its fire resistance level. It is not only suitable for the research, production and quality inspection departments of electrical and electronic plastic or rubber products and their components such as lighting ...
Introduction of glow-wire tester: The glow-wire tester uses simulation technology to evaluate the fire hazard caused by thermal stress caused by heat sources such as hot components or overload resistors in a short period of time. It is one of the series of electrical and electronic components fire hazard test instruments. It is suitable for evaluating the flammability test and light-off temperatur...
Application: The salt spray test machine is suitable for the surface treatment of various materials, including paint, electroplating, organic and inorganic film, anode treatment, anti-rust oil, etc. YWX/Q-010_Salt Spray Test Machine Salt spray test is an environmental test that mainly uses artificially simulated salt spray environmental conditions created by salt spray test equipment to assess th...
Environmental chamber is the general name of all test chambers that simulate natural climate environment. The representative products include salt spray test chamber, high and low temperature test chamber, constant temperature and humidity test chamber, ultraviolet aging test chamber, xenon lamp aging test chamber, ozone aging test chamber, oven, etc. . The high and low temperature humidity test c...
1. Operation steps: 1. First connect the probe and optical fiber to the corresponding position of the integrating sphere, and fix it. 2. Turn on the DC power supply of the integrating sphere system configuration. 3. Turn on the computer, then open the computer desktop test software, and select “System Settings” on the software, and connect the DC power supply, the electric parameter me...
Electromagnetic Interference(EMI Receiver) Introduction: Electromagnetic Interference (EMI receiver) is electronic noise that interferes with cable signals and reduces signal integrity. EMI Receiver is usually generated by electromagnetic radiation sources such as motors and machines. EMI Receiver (Electromagnetic Interference) has two types: conducted interference and radiated interference. Condu...
Combination waves generator or surges Generators are typically benchtop pieces of equipment that weigh a lot. Ground planes with links to the earth are needed for the safe operation of a transient generator in electromagnetic test settings. Testing three-phase power line systems necessitate more extensive coupling/decoupling networks, which significantly increases the overall size of the system. A...
Goniophotometer is the main measurement equipment for the light distribution performance test of lamps and luminous. It can be used to measure the spatial light intensity distribution of lamps or light sources, total luminous flux and lamp efficiency and other parameters. The composition of the Goniophotometer system includes: precision turntable and control system, spectrum analysis system, stand...
中文简体
English
Русский
Español
Português
Türkçe
العربية
Deutsch
Polski
Italiano
Français
한국어
ไทย
Tiếng Việt
日本語