In normal applications, manufacturers of high and low temperature test chambershould pay attention to maintenance and upkeep after conducting experiments, which can increase the service life of the equipment and also make the experiments more effective. 1. Before conducting an experiment, it is necessary to check whether the water level line of the storage head is too high or too low. If the water...
Probe Test A tamper-resistant receptacle shall not permit contact to be made between the probes shown in Figure 139.1 and Figure 139.2 and any live part of the receptacle through the outlet slots when tested as described in this section. UL498 Figure 139.1 Twelve previously untested devices are to be used for this test. The probe shown in Figure 139.1 is to be applied to each of the outlet slot op...
In photometry, the measurement of the power of light is carried out using two different instruments: a goniophotometer and an integrating sphere. Both have their own salient features which make them appropriate for different types of flux testing and measurement. Although they are used for the same purpose i.e. optical power measurement, they have different characteristics and principles. While it...
At the beginning of the last century, a xenon lamp aging test chamber appeared in the world. It is composed of a carbon arc lamp as the light source, the lamp tube is vertically placed in the center of the instrument, and is surrounded by a filter system and a rotating sample frame. The test sample is installed facing the light source and rotates around the central lamp like a conveyor belt. After...
Assembly Security Test A flush receptacle having a 5-15R,5-20R,6-15R, or 6-20R configuration is to be mounted in the fixture described in Figure 124.1, and 50 lbf (220 N) is to be applied, as shown in Figure 124.2, for a period of 10 s by means of a push-out tool inserted into the slots of the receptacle. The push-out tool required for configuration 5-15R is to be as shown in Figure 124.3. Recepta...
The high and low temperature humidity test chamber, also known as the temperature shock test chamber and the thermal cycle chamber, is a device used to test the performance of products under high temperature, low temperature, and humidity environments. It is widely used in industries such as electronics, electrical appliances, automation instruments, aerospace, and automotive. The high and low tem...
Household power supply specifications will vary by region, but generally speaking, voltage values are usually between 100V and 240V, while the most common frequency values are 50Hz and 60Hz. Factories using polyphase power will have more differentiated power supplies with higher voltages and more specialized plugs and sockets for larger equipment, but will still use the general power supplies show...
With the continuous development of technology, various electronic devices are becoming more and more widely used in our lives. Electronic devices usually need to be tested in a controlled environment to ensure their functionality and reliability. Walk-in dust test chambers are commonly used testing equipment that can perform dustproof performance tests on electronic devices according to the IP5X d...
Switches MANUALLY OPERATED MECHANICAL SWITCHES which -control currents exceeding 0,2 A r.m.s. a.c. or d.c., and/or – have voltage across the open switch contacts exceeding 35 V (peak) a.c. or 24 V d.c. shall meet one of the following requirements: a) The switch tested as a separate component, shall comply with the requirements and tests of IEC 61058-1, whereby the following applies: – ...
中文简体
English
Русский
Español
Português
Türkçe
العربية
Deutsch
Polski
Italiano
Français
한국어
ไทย
Tiếng Việt
日本語