RF LED light is emitting diode by converting the RF energy into light energy. LED lights are not always RF LED lights, for example, if the maximum working frequency of LED light is less than 9kHz, such as light with non-light source or directly supplied by DC power source (no drive power module), then it is not regarded as RF LED light. RF LED lights certification and testing requirements: Federal...
EFT is short for Electrical Fast Transient, which refers that the burst has specific duration (defined as 15 ms) and specific pulse period, and the single impulse from burst has specific repetition period, voltage peak, rise time and pulse width. The duration of burst is 15 ms, the pulse interval is 300ms, width of single pulse is 50ns±30%, the amplitude of pulse is 2KV, pulse rising time is 50n...
During World War II and after the war, Western countries, especially the United States, have established a series of environmental testing ground, laboratory and developed environmental testing standards. Required by the US military, all weapons equipment, parts, materials, and ammunition must be sent to the environment laboratory to simulate environmental testing, and then sent to environmental t...
LED blue light hazard is to evaluate the photochemical damage of the blue radiation to the retina. In practice, we may observe the light source or luminaire emitting surface in different regions from different angles. Therefore, in order to meet a variety of applications, IEC 62471 provides that the blue light hazard classification should be based on the radiation exposure values (weighted irradia...
IES LM-79-08 Approved Method: Electrical and Photometric Measurements of Solid-State Lighting Products. IES LM-79 standard is mainly for photoelectric performance measurement. Generally it is for whole lamp. Main measurement parameters as follow: Electrical Measurement: Voltage, Current, Power and Power Factor. Colorimetric Measurement: CCT, CRI and Chromaticity Coordinates Photometric Measurement...
Integrating Sphere is a hollow sphere which inner surface coated with white diffuse material. There are one or several apertures on the wall of the integrating sphere. The aperture is used as light well and receiving aperture for placing light-receiving device. The inner wall of integrating sphere should be good sphere. It usually requires that deviation from the ideal spherical should be less tha...
Spectroradiometer & Integrating Sphere System as main test device to measuring LED lamps, it’s as a most important device to judge the quality of lighting products. How to operating these device and make it have better work condition became the point, so the standard operating procedures of device is necessary. In the practice, the standard operating procedures have two parts: one is standar...
1. The allowable tolerance range of standard light source calibration and retest results is as follows: X, Y Chromaticity Coordinates: ±0.0008 Color Temperature: ±10K Luminous Flux: ±5‰ SLS-50W_Standard Lamp 2. The allowable tolerance range of contrast light source/ luminaires retest results as follows: X, Y Chromaticity Coordinates: ±0.0050 High Color Temperature: ±150K Low Color Temperatu...
The most critical factor that affects the quality of lighting is the luminous distribution performance of lamps. Using scientific testing methods and selecting the appropriate test instrument is the basis of obtaining accurate luminous distribution properties of luminaires. The test of luminaires’ luminous distribution is an important part of luminaire design and lighting design for quality con...
中文简体
English
Русский
Español
Português
Türkçe
العربية
Deutsch
Polski
Italiano
Français
한국어
ไทย
Tiếng Việt
日本語