LISUN LVD-100KG Electrodynamic Vibration Generator System – After Sales Questions and Answers

LVD-100KG/LVD-100KG-6D Electrodynamic Vibration Generator Test Table  is according to IEC 60068, IEC68-2-6, JJG189-97, GB/T13309-91, GB2423 and other relevant standards.

• LVD-100KG: Combined the Vertical and Longitudinal total 4 directions in one test table.
• LVD-100KG-6D: Combined the Vertical, Level and Longitudinal total 6 directions in one test table.

Q1: How to avoid moving or making too much noise when the vibration table is working
A1: It is recommended to place the vibration table on the ground floor.
The equipment accessories include the following foot cup accessories:

Foot cup accessories

Put all four feet of the vibration table into the foot cups, and then fix the foot cups on the ground with screws to prevent the vibration table from moving during operation.

Q2: How to fix the sample on the vibration table
A2: There are screw holes on the Lishan vibration table. Customers can make any suitable fixture according to their own samples, reserve holes of the same size on the fixture, and then fix the fixture and sample on the vibration table with screws of the corresponding size.

Fixing fixture

Q3: Why the set vibration intensity is the same, but the actual amplitude is different
A3: The same vibration intensity, but the weight and center of gravity of the sample are different, so the amplitude obtained will be different. Therefore, if different types of samples need to be replaced for testing, the vibration intensity needs to be readjusted.

Q4: How to ensure the safety of the testing process
A4: Severe vibration during vibration testing may cause samples to fall off or parts to splash. To ensure safety, the test bench needs to be tested in a closed environment, and personnel are prohibited from approaching during the process.

Electrodynamic Vibration Generator System LVD-100KG

Lisun Instruments Limited was found by LISUN GROUP in 2003. LISUN quality system has been strictly certified by ISO9001:2015. As a CIE Membership, LISUN products are designed based on CIE, IEC and other international or national standards. All products passed CE certificate and authenticated by the third party lab.

Our main products are Goniophotometer, Integrating Sphere, Spectroradiometer, Surge Generator, ESD Simulator Guns, EMI Receiver, EMC Test Equipment, Electrical Safety Tester, Environmental Chamber, Temperature Chamber, Climate Chamber, Thermal Chamber, Salt Spray Test, Dust Test Chamber, Waterproof Test, RoHS Test (EDXRF), Glow Wire Test and Needle Flame Test.

Please feel free to contact us if you need any support.
Tech Dep: Service@Lisungroup.com, Cell/WhatsApp:+8615317907381
Sales Dep: Sales@Lisungroup.com, Cell/WhatsApp:+8618117273997