IEC 60400:2004 Lampholders for tubular fluorescent lamps and starterholders

IEC 60400:2004 is a standard that focuses on lampholders for tubular fluorescent lamps and starter – holders. It sets out the technical and dimensional requirements for these components. The standard aims to ensure that the lamps fit correctly in the lampholders and the starters fit properly in the starter – holders, with a special emphasis on safety aspects.

In addition, IEC 60400:2004 also details the specific test methods. These testing procedures are utilized to verify the compliance of lampholders and starter – holders with the previously mentioned requirements, making sure that they can work safely and stably when used with corresponding fluorescent lamps and starters.

LISUN supplies the fully test solutions for the following IEC 60400:2004, please see the below excel table:

IEC 60400:2004 Clause and Subject	LISUN MODEL
7.4 protection against ingress of dust or water	SC-015&JL-X
8.1 10N force Test finger(Figure 41)	SMT-02T10
11.1 Resistance to dust	SC-015
11.2 Resistance to moisture	YWX/Q-010
18 Resistance to excessive residual stresses (season cracking) and to rusting
Annex B Season cracking/corrosion test
12 Insulation resistance and electric strength	WB2681A
14.2 pendulum hammer test	IK07-10
14.3&15.1 torque test	CH338
16 Creepage distances and clearances	CK-1
17.1 resistant to heat	GDJS-015B
17.2 ball-pressure test	ZBP-T
17.4 glow-wire test	ZRS-3H
17.5 needle-flame test	ZY-3
17.6 proof tracking test	TTC-1

Tags：CH338 , CK-1 , GDJS-015B , IK07-10 , JL-X , SC-015 , SMT-02T10 , TTC-1 , WB2681A , YWX/Q-010 , ZBP-T , ZRS-3H , ZY-3