LED Module and LED Lamp

For the LED Module and LED Lamp design and manufactory, Lisun can supply a full quality control test solution. Please feel free to contact with Lisun Sales Dept for the detail technical solution and formal quotation at: Sales@Lisungroup.com

1. Photo, Color and Electricity Test System
Integrating Sphere Spectroradiometer System for LED
LPCE-3(LMS-7000) is according to LM-79 and LM-80, and it is a high accuracy test system which is similar as US and Germany level. The system can test the color parameters such as CCT, CRI, Spectrum, Flux, Flux Efficient, Power, Power Factor, Voltage, Current and so on.


Integrating Sphere Spectroradiometer System for LED
LPCE-2(LMS-9000B) is accepted by many LED luminaire manufactory. It meets LM-79 and LM-80. The system can test the color parameters such as CCT, CRI, Spectrum, Flux, Flux Efficient, Power, Power Factor, Voltage, Current and so on.

 


2. Compact Goniophotometer
The compact goniophotometer of LSG-1200A is used to measure the luminous intensity distribution curve, intensity data, spread angle and other parameters for Chip LED, LED Module, LED Bulb, LED spotlight and CFL Lamp which diameter is less than 18cm. It meets the requirements of IEC, CIE and LM-79 standards.


3. EMI and EMC Test System
EMI-9KB/EMI-9KA is the EMI Receiver system which are fully meets CISPRl6-1, GB17743, FCC, EN55015 and EN55022. It is used to test the LED driver, LED luminaires and other electronic products. Detection frequency range: 9kHz~300MHz (EMI-9KB) or 9kHz~30MHz (EMI-9KA).


 

4. Electrical Safety Test
LED Power Driver Tester: WT2080 is according to GB/T 24825-2009 and IEC 62384:2006. It can measure the following parameters: Input Characteristics Test (AC&DC), Output Characteristics Test (AC&DC), Input Start Characteristics Test (DC).
Programmable Withstanding Voltage & Insulation Test: LS9923.


5. High and Low Temperature Humidity Chamber: GDJS-*B

The High and Low Temperature Humidity Chamber: GDJS-015A. Lisun special designed based on lighting fixtures temperature aging request. It used the Finland Digital humidity sensor, TEMI controller and water purification system. The GDW/GDJS chamber can work with Lisun LEDLM-80PL to do the LED optical aging test accroding to LM-80 and LM-82