LEDs Test Method: Photoelectric Characteristics Testing Method – Switching Time

3000 type：Photoelectric Characteristics Testing Method

Method 3001: switching time

1 Objective

Measure the turn on time t_on (open delay time t_d(on) ＋rise time t_r ）of the measuring LED device and the turn off time t_off （closed delay time t_d(off) ＋decrease time t_r ).

2 Test chart

Picture 13 method 3001 test chart

D：Measuring LED device

G1：High resistance current pulse generator

G2：Dc bias current source

G3：Dc voltage bias source

Rd: The resistance of the impedance matching generator

RL: Load resistance

M：Measuring instruments

PD：Photoelectric diode

Syn：Synchronous signal

Note: the switching time of the photoelectric diode, experiment circuit and measuring instrument delay time, the input current pulse rise time and decrease time should be short enough to ensure that they won’t affect the measurement precision. The average output power obtained from the pulse top needn’t to equal the continuous radiation power of the sum of the dc bias current and the input pulse current.

3 Test procedures

Add the specified dc and pulse current to the device being tested, use the measuring instruments M to measure the switch time. 100% of the radiation output power level is the average output power obtained at the top of the radiation pulse. 0% level is the output power of the dc bias current

4 Rated condition

Environment and tube temperature

DC bias current

Optical window

Optical structure

About Lisun Group:

Lead in CFL and LED Tester. Click to our product lists:

Goniophotometer
Spektrofotometer
Integrating Sphere
Colorimeter
Photometer
LED Test Instruments
CFL Test instruments
EMC testing
Electronic Ballast Tester
Equipments for Testing Electronic components
Electrical Safety Tester
Environmental testing equipment
AC and DC power supply
Spectrophotometer

Related posts:

1. LEDs Test Method: The Electrical Characteristics Testing Methods
2. LEDs Test Method: Light Characteristics Measuring Methods
3. Lisun LED Test Solution and Measuring Method Part2: Switching, Color, Thermal and Reliability Characteristics
4. Lisun LED Test Solution and Measuring Method Part1: Electrical and Optical Characteristics
5. LEDs Test Method: Peak Emission Wavelength, Spectral Radiation Bandwidth and Spectrum Power Distribution
6. Semiconductor LEDs Test Method
7. LEDs Test Method: Luminous Flux and Luminous Efficiency
8. LEDs Test Method: Radiation Flux and Radiation Efficiency
9. Maximum Rating and General Requirements of LEDs Test
10. Testing Rules for Lighting Products Part3: Life Test and Aging Test